|
Clamp frame opening in a rotary or single station machine will normally be a rectangle configuration.
The long sections or the, front and rear sections, will normally remain full length, adjustment being made by releasing and sliding frames forward and back.
When determining the sizes required for various side or removable sections begin with the smallest tool size. For each additional larger frame add a combination of sizes using the choices shown above. These sections can be mixed and matched to suite almost any tool size, to fit special applications you can leave a small gap between frames and at the ends or cut to size.
NOTE: Frames are designed to enable cylinders to pass over end of mounting framework.
Cylinder hose connections can be quick disconnect or male/female swivel, hoses can be various lengths, (when using longer hoses put a coil or loop in the hose to keep it from hanging down.)
We carry a variety of hose lengths and fitting styles, and remember that parts and pieces of existing frames can also be used.
|
|
